新闻资讯

First of all, the operation system and procedures of mineral processing machinery and equipment must be observed before operation. For example, before starting up, the connection between equipment components is firm, the lubricating oil of the equipment is sufficient and the power supply is in good condition. After checking, the equipment is started up, and the auxiliary equipment should be started up before opening the main equipment. When formally into the beneficiation process, should focus on the mechanical linkage parts to check, to ensure that the equipment in the pipeline, control valve and the tank is not blocked and the phenomenon of the card slot, in addition should always check the dial value of each component, and the corresponding record of the data on the dial. When the mineral processing machinery to complete the work after the shutdown of the equipment to check the internal parts of the material, to confirm that no material has continued to enter or material residue, and then stop the equipment for gas supply, water supply and drug supply, and finally stop processing. Only as described above in strict accordance with the operating procedures and operating standards of mineral processing machinery, in order to fundamentally ensure the safety and smoothness of the operation of mechanical equipment, and thus ensure the operating efficiency of mineral processing machinery.


The second important factor that affects the operating efficiency of mineral processing machinery and equipment is the effectiveness of its lubrication system. Only by ensuring the cleanliness of the lubrication system of mineral processing machinery can the mechanical equipment have an efficient operating cycle and a long-term service life. Usually, mineral processing machinery will crush the ore during the mineral processing process. This process will form a large amount of dust and slurry. Because the dust particles are extremely small and the slurry is pervasive, they can easily lead to blockage of the lubrication system in mineral processing machinery and equipment. In addition, the lubricating oil tank of some mineral processing machinery and equipment has poor sealing properties, making it easier for these substances to enter the oil tank to block it. Therefore, in order to ensure the cleanliness of the lubrication system of mineral processing machinery, the first task is to attach great importance to dust control in mineral processing. For example, on the one hand, electrostatic adsorption devices can be installed in the system, timely ventilation treatment can be carried out and water spray dust removal can be carried out in the lubrication system, on the other hand, the tightness of lubricating oil pipelines can be enhanced, thus improving the cleanliness of the lubrication system of mechanical equipment through various methods, thus ensuring the high efficiency and high quality of mineral processing machinery.


Optimizing the specific production process of the mineral processing process can promote the work efficiency of the overall mineral processing machinery system. For example, the water obtained from mine tailings is recycled through technology and put into the production process again as raw materials to realize the recycling of industrial water, which not only makes industrial wastewater achieve zero pollution and zero discharge in environmental protection, but also saves production costs and reduces production input. In addition, the traditional secondary flotation operation can easily lead to severe pollution to the environment, which can be improved by only one selection flotation operation. One selection can accurately locate the mine site, and then the operation is relatively simple, and the power consumption and equipment loss will be greatly reduced, which can effectively reduce pollution, simplify operation and reduce production cost. In addition, the pressure filtration process of moisture should be strengthened in the process of ore dressing, so that the moisture separated from the concentrate can be recovered to the production system for recycling, and water can be saved to a certain extent.